Register new node

To register a new node to Great Bear, complete the following steps.

Prerequisites

  • You will need the HARDWARE IDENTIFIER of the new node to register it.
  • The physical installation of the node is not covered in this procedure.

Steps

  1. Open the Great Bear dashboard, then select Nodes.

  2. Select Register Node in the top-right section of the dashboard. Register Node Register Node

  3. Enter the HARDWARE IDENTIFIER of the new node. Check that the identifier is correct, you can’t change it later unless you delete and re-register the node, see Delete node.

  4. Enter a name and a description for the node. You can change these values later if needed (for details, see Configure node).

  5. Select Apply.

    The new node is added to the list of nodes. It’s Site is automatically set to not assigned. Now you can Add node to site.