Getting started with Auvidea NVIDIA Jetson TX2 NX

JNX30M carrier board JNX30M carrier board


To get started with the Auvidea NVIDIA Jetson TX2 NX you will need:

  • A 12V 3A DC power supply or PoE switch.
  • Access to the Internet via wired Ethernet connection.
  • Access to the Internet needs to be via IPv4.


  1. Having received the Auvidea NVIDIA Jetson TX2 NX, make a note of the serial number - this is the HARDWARE IDENTIFIER of the node and it will be used during the registration process.

  2. Next, connect the TX2 NX to power and Ethernet. Make sure there is access to the Internet via IPv4.

  3. That’s it! Next you can Start using your node.

Further information

The Auvidea NVIDIA Jetson TX2 NX is shipped with the latest available Great Bear OS and software stack installed. The Great Bear support team will announce any required updates to the node image as part of our on-going maintenance life-cycle. Node image updates can be performed remotely over the air by our support team, coordinated through a schedule aligned with node operational considerations and connectivity to the internet. On occasions, it maybe necessary to update the device locally through the NVIDIA USB protocol to flash the device with an image supplied to you by the Great Bear support team.
Please refer to Flashing NVIDIA Image